Re: BRF+ For User Defaults

Hi Madhu,

Thanks for that input.  I went through it all once again and I got it to work but I have an issue.

Basically, in my decision table, if I remove the CONNECTOR (System), then I am able to get the application to return a value - but that's not going to work for me.

I need the decision table to return a value based on the CONNECTOR input.

However, despite my providing a valid value for CONNECTOR (System), the decision table seems to not match correctly.

Here's a screenshot of a simulation.

Clearly, my REQTYPE is being matched towards the bottom of the screenshot.  But the CONNECTOR variables is a blank, despite my having entered a value for it.  I'm not clear whether I missed a step, but it would seem that the loop and the ruleset are working as this will return a valid match if the CONNECTOR were to have a value.

Any ideas?

Thanks,
Santosh